'' USB device over current status detected '' is a boot screen error which pops up when you start the system. As mentioned in its message, a defective USB device or connector is the reason behind this error. Along with this error some users have reported to smell burning odor.
It is commonly experience when building a new PC. Following this your system usually shuts down in 15 seconds. This is done to protect your system from further damages. Since this error generally occurs because of a hardware problem there are some simple solutions which aids to fix this by yourself.
In this article, I will be examining about the Fixing USB Device Over Current Status Detected | System Will Shutdown After 15 Seconds. You can try these solutions to continue using your computer back to normal.
Let's get started,
1. Check USB Devices
A malfunctioning device is most often the cause for this error. Before you try any other solutions given below, you need to ensure that all of the devices connected to your PC are working properly. A simple way to find out the culprit device is by removing the USB devices one by one and reconnecting them again.
2. Check USB Ports
If the connected devices appears to be fine, then the actual problem might be in the USB ports. There is also a possibility that the USB ports present on your PC are either damaged or not connected properly. The ports can be easily be damaged due to reported use or any physical impacts. In this case, you can try connecting the USB devices to other additional ports.
3. Check Jumpers
A jumper is a small component which connects your USB port to the motherboard. Each USB port is connected through a jumper. So each of them needs to be checked and make sure that they are not with damages. If found any damages, you must take necessary steps to replace them.
4. Update BIOS
Basic Input/ Output System System (BIOS) is a firmware model on your computer which makes sure that all of the hardware components are functioning properly. It is the primary software which runs during the boot initialization. If the BIOS is outdated, they may fail to recognize the connected USB devices. Therefore, sometimes this error might just be removed by updating the BIOS firmware.
5. Replace Motherboard
If your motherboard is old enough and too over used it is possible that it isn't working anymore. Most often this happens if the modules are damaged. For checking whether the motherboard is damaged or not, you can temporarily use another motherboard. If the motherboard isn't working properly, you may have to replace it with a new one.
No comments:
Post a Comment